Description
Our 6mm diameter, ribbed galvanised steel J-Pins are a heavy duty fixing solution which can be used in conjunction with a large number of grass protection meshes, grass reinforcement meshes, membranes and ground reinforcement products we currently stock. These are available in pack quantities of 1, 5, 10, 25 and 100 to ensure you can order the exact amount for your upcoming project, we would recommend studying the installation guide of the product you are wanting to fix with the j-pins to ensure you order enough fixings.
Galvanised Steel J-Pegs
The J-Pegs are made from ribbed galvanised steel, which is ideal for use on hard or uneven ground where U-Pins are unsuitable.
J-shaped pegs can be used to secure the base of galvanised steel wire to the ground. Securing wire mesh at ground level is done to stop animals burrowing underneath fences and helps to keep browsing animals out by stopping digging. J Pins can be pegged over the bottom horizontal wire in rabbit netting, chicken wire, stock fencing, deer mesh, garden mesh fencing and fox proof fencing.
What are typical uses for J-Pegs?
Typical J-Peg uses may include:
- Wire fences (the base)
- Agricultural livestock fencing
- Rabbit fencing meshes
- Domestic garden fences
- Tent pegs
- Fruit cage netting
How to install products using J-Pins
This fixing solution is used to secure membranes, mats, grids, grass reinforcement meshes and grass protection meshes into uneven or hard ground. They may also be used to fully install a U-Pin. The length of the J-Peg is 285mm long so it is easy to push this pin into tougher ground to secure the products.
The installation is simple. First ensure that the pin sits flush with the ground, so that there is no risk of tripping or falling over the pin. If the ground is hard and it is difficult to push the pin into the ground, then a rubber or wooden mallet or a hammer could be used.
What is the recommended number of J-Pegs for GrassMesh and TurfMesh?
J-Pegs can be used for the installation of GrassMesh and TurfMesh.
The following number of pegs are recommended for this installation:
- 25 Pins per 1M x 10M Roll
- 100 Pins per 2M x 30M Roll
For more information on our 6mm J-Pegs, download the product guide found in the downloads tab or if you have questions about any of our other products, please do not hesitate to contact a member of our knowledgeable and helpful team.
